It is called a cutlass bearing and easily replaced.
Nick
shaislet@speedsite.com wrote:
>Hello fellow Pacific 911s owners,
>
>Perhaps the Pacific and Ericson models were alike in this respect but just
>in case....
>I need to replace the bearing inside the prop shaft strut. Where might I
>go to buy a replacement. In case I'm not using proper terminology, I am
>refering to the strut or arm that extends down in front of the rudder and
>holds the prop shaft. The bearing or mechanism inside the eye needs to be
>replaced.
>
>Also, I believe the measurement is 1-1/4" from the dripless to the aft
>section of the point at which the shaft enters engine.
>
>Any information would be appreciated,
>
>Steve Haislet
>Latest Trick
>
>
>
>
Received on Sat Nov 22 19:35:18 2003